Call Us

01563 529435
Hire Hotline

0844 391 0201

Hypertherm Flushcut Starter Kit

  • Product Code:: ZBC428713
  • Product Pdf:

Hypertherm Flushcut Starter Kit

The Hypertherm Flushcut consumables have been specifically designed to allow Powermax users to cut attachments, lugs, pad eyes and other features as close to the base as possible without piercing or damaging the workpiece. The nozzles are designed at an angle and flat guiding shields enabling flush cutting that leaves less than 5mm (3/16”) residual on the base or work piece, reducing grinding and secondary repair operations. 

Part no. ZBC428713

FEATURES

The angled nozzle bore of FlushCutTM consumables reduces secondary grinding by leaving minimal residual material

The 45 degree angle of the FlushCut arc allows for lugs and attachments to be removed with a flat bottom, increasing the chances for the lug or attachment to be reused

The guiding flat on the shield helps operators avoid digging into the base plate, reducing the need for costly repairs

Suitable for:

Powermax125 Durmax & Hyamp Torch Series

Powermax105 Duramax Torch Series 


Write a review

Note: HTML is not translated!
    Bad           Good